Lk8 Light Installation (Optional) - Napoleon GT8P Installation And Operation Manual

5.6

LK8 light installation (optional)

Turn off the electrical and gas supply to the appliance.
A.
Remove the frame from the appliance by removing the 2
B.
black securing screws from the top, and the 2 silver hex
head securing screws from the bottom.
Lay the frame down on its front, being careful not to
C.
scratch the finish.
Starting at the top of the frame, take one light assembly
D.
and carefully snap it into place in the hole provided.
Repeat for each of the light assemblies. The wires on the
top 2 light assemblies will need to be fed in behind the
heat shields.
NOTE: When installing the light kit be careful not to scratch
your fingers on any of the exposed screws in the frame.
Using illustration as a guide, connect the light assemblies
E.
to the appropriate flags on the wire harness. The wire
harness is labeled (TR) top right, (BR) bottom right (TL)
Top left and (BL) bottom left.
Secure the wires into the clips at both sides and the
F.
bottom of the frame. Use the extra clips provided to retain
any loose wires.
Re-attach frame onto appliance.
G.
Remove the control panel by removing the 2 screws
H.
securing it along the top edge. Leave the wires
connected to the ON/OFF switch.
Place the transformer into the bottom of the appliance.
I.
Plug the transformer into the receptacle.
Lay the control panel flat along the bottom edge of the
J.
frame. Attach one of the wire leads from the transformer
to the lead on the wire harness labeled "TRANS", and the
other to the ON/OFF switch. Attach the last lead on the
wire harness labeled "SWI" to the ON/OFF switch.
Re-secure the control panel.
K.
Turn on the gas supply and electrical power.
L.
finishing
CLIPS X5
W415-1367 / B / 01.09.19
EN
27