IKEA HYGIENISK Manual page 14

ENGLISH
The rinse aid empty notification
The rinse aid helps to dry the dishes without
streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the rinse
aid indicator is turned on notifying to refill
rinse aid. If you are using multi-tabs
containing rinse aid and you are satisfied
with the drying result, you can deactivate
the notification for refilling rinse aid.
However, we recommend that you always
use rinse aid for best drying performance.
If you use standard detergent or multi-
tablets without rinse aid, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse aid empty
notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously
the indicators
and start flashing and the
display is blank.
2. Press .
• The indicators
are off.
• The indicator
• The display shows the current setting:
= the rinse aid empty notification
is activated (factory setting).
3. Press to change the setting.
= the rinse aid empty notification is
deactivated.
4. Press on/off to confirm the setting.
and until
, , , ,
, , ,
still flashes.
Acoustic signals
Acoustic signals sound when a malfunction
of the appliance occurs. It is not possible to
deactivate these acoustic signals.
There is also an acoustic signal that sounds
when the programme is completed. By
default, this acoustic signal is activated and
it is possible to deactivate it.
In addition, an acoustic signal will sound
before the AutoOpen will open the door.
This acoustic signal stops only if AutoOpen
is deactivated.
How to deactivate the acoustic signal for
the end of programme
The appliance must be in programme
selection mode.
1. To enter the user mode press and hold
simultaneously
the indicators
and
display is blank.
2. Press
• The indicators
and
• The indicator
• The display shows the current setting:
= Acoustic signal on.
and
3. Press
= Acoustic signal off.
4. Press the on/off button to confirm the
setting.
How to set the colour of the TimeBeam
It is possible to change the colour of the
TimeBeam to match the colour of the
kitchen floor. There are several colours
available. The TimeBeam can also be
deactivated.
and
, ,
start to flash and the
, ,
go off.
continues to flash.
to change the setting.
14
until
, ,
,