Loading The Cf Card Into The Unit; (Dp-02Cf Only); Starttup & Shutdown; Starting Up The Unit - Tascam DP-02 Owner's Manual

1 – Starting out with your DP-02/DP-02CF IMPORTANT SAFETY INSTRUCTIONS
Loading the CF card into the unit (DP-02CF only)
On the DP-02CF, a CF card is used as a recording media
for recording and playback. The CF card should be loaded
into the unit before the power is turned on.
1. Slide the door to open the
slot on the side panel to the right, and gently insert a
card, label side up, into the unit's slot.
CAUTION
If the card is the wrong way up, or backwards, when
inserted into the slot, applying excessive pressure may
damage the slot or the card. Do not force the card in
to avoid damage to the unit or the card, remove and
re-orient the card so that it slides in easily.
Starttup & shutdown
Read this section to understand how to power up and
power down the unit.
WARNING
When switching the unit on and off, we suggest that
you turn down the volume of any speakers or ampli-

Starting up the unit

Connect the power adaptor to the unit, the power cable
to the power adaptor, and the power cable to the power
supply.
Press the switch on the top panel to turn on the
POWER
unit. The display shows a welcome message.
The system is loaded, and the last saved song is then loaded.
The ACCESS indicator flashes to show the hard disk/CF
card is in use while the song is being loaded, and the display
shows the current operation.
COMPACT FLASH CARD
2. Close the slide door. With the door opened, the
DP-02CF cannot be used.
NOTE
To use a new CF card, you need to format the card first
(see "Formatting a disk/card" on page 39).
Ejecting the card:
Turn off the power to the unit first, slide the door to open
and remove the card by hand (there is no eject lever on the
unit).
CAUTION
Do not remove the card when the unit is turned on.
Always turn the power off before you take the card
out from the unit.
fiers connected to the unit. Also, do not wear head-
phones connected to the unit when switching power
on or off. This will avoid damage to speakers, etc. and
possible damage to your hearing.
When the ACCESS light goes off, the display shows the
"home screen":
T I P
You can reach this screen from most operations by
pressing HOME or repeatedly pressing the NO/EXIT
key.
NOTE
When the power is turned on without a CF card loaded
into the unit, the home screen shows as follow:

TASCAM DP-02/DP-02CF