Move ® Insert; Open - Tascam DP-02 Owner's Manual

IMPORTANT SAFETY PRECAUTIONS 2 – Advanced techniques
MOVE INSERT
®
This function takes the section of a track or tracks marked
by the and points, and moves it to the chosen track
IN OUT
or tracks, inserting it as new material, starting at the TO
point.
After the operation, the selected section of the source
between the and points is replaced by silence.
IN OUT
The insert operation adds the selected section as new mate-
rial to the destination. Nothing is overwritten on the desti-
nation, as any material following the TO point is moved to
the end of the newly-inserted section. The track is therefore
longer than it was before the operation.
IN OUT
IN OUT

OPEN

This function "opens up" a silent gap between the
points on the chosen track or tracks.
OUT
The source and destination are the same, and after the
operation, the track is split at the
rial which followed the point now moved to follow the
IN
point. The result is therefore longer than the original.
OUT
IN OUT
IN OUT
0
TASCAM DP-02/DP-02CF
TO
TO
and
IN
IN point, with the mate-
You can change the following values:
SOURCE.TRK This sets the source track or tracks from
which the section is taken. Choose 1 through 8 to select an
individual track. Choose 1/2, 3/4, 5/6, 7/8 to select a pair of
tracks. Choose 1-8 to select all tracks.
DESTINATION. TRK This sets the destination track or
tracks into which the selected section is inserted. What you
can select here depends on what you have selected for the
source track. If you have selected a single track, you can
select tracks 1 through 8 here. If you have selected a pair
of tracks (for instance, 1/2), you can only select track pairs
here. If you have selected all tracks (1-8), then this is the
only option available to you here.
Press to perform the operation or
YES/ENTER
leave this screen.
There is only one value that you can change:
OPEN.TRK Select an individual track (1 through 8), a
pair of tracks (1/2, 3/4, 5/6, 7/8), all of the tracks (1-8) or all
tracks (ALL).
Press to perform the operation or
YES/ENTER
leave this screen.
to
NO/EXIT
to
NO/EXIT