Setting The Installation Options In A Batch - Samsung AC026NNNDKH Service Manual

• If any of SEG5 and SEG6 is set to a value in the range A to F, the main address of the indoor unit does not change.
• If SEG3 is set to 0, the indoor unit maintains the existing main address even if SEG6 is set to a new value.
• If SEG9 is set 0, the indoor unit maintains the existing RMC address even if SEG11 and SET12 are set to new values.

4-1-3 Setting the installation options in a batch

Option No. for an indoor unit address: 02XXXX-1XXXXX-2XXXXX-3XXXXX
1 Make sure that the power is supplied to the
indoor unit. If the indoor unit is not plugged in, it
must include a power supply.
2 Set the installation options of indoor units, by referring to the following table and by following the steps in Common
steps for setting the addresses and options on page 4-1.
• The installation options of indoor units are set to like a below table by default.
Model
Installation option
• The SEG20 option, Individual control with remote control, allows you to control multiple indoor units individually
by using the remote control.
SEG1
Option
Function Page
Indication Details
Indication
and
0
details
Option SEG7
Function Page
Indication Details
Indication
and
1
details
Samsung Electronics
AC026NNNDKH
AC035NNNDKH
AC052NNNDKH
AC060NNNDKH
020000-100001-200000-
300000
SEG2 SEG3
Whether
Mode to dry the
Evaporator
Indication Details
Reserved
2
SEG8 SEG9
Use of drain
pump
Indication Details
0 Disuse
Reserved
1 Use
Use with
2 3 minute
delay
020000-100031-200000-300000
SEG4
Use of external
temperature Use of central control
sensor
Indication Details Indication
0 Disuse 0
1 Use 1
SEG10
Compensation of the
wind-free fan RPM
Indication
AC026NNNDKH,
AC035NNNDKH,
Model
AC052NNNDKH,
Reserved
AC060NNNDKH
0
1
2
3
Indoor Unit
AC071NNNDKH
SEG5 SEG6
Compensation of
the fan RPM
Details Indication
Disuse 0
Use 1
SEG11 SEG12
Dew removal
operation in
Wind-Free mode
Details Indication
AC071NNNDKH
0
3 step ↑
Default
1 step ↑ 2 step ↑
2 step ↑ 1 step ↑
1
3 step ↑ Default
Details
Disuse
High
ceiling
mode
Details
Maintain
blade status
in Wind-
Free mode
(Default)
Cooling
operation
by opening
the blade
4-7