Nordson iControl 2 Instruction Sheet

iControl

Touch Screen Installation

Pedestal Installation

Figure 1 Touch Screen Replacement
1. Touch screen
E 2015 Nordson Corporation
r
2 Display Monitor Touch Screen Kit
Use this guide to install or replace the iControl
WARNING: Allow only qualified personnel to perform the following tasks. Follow
the safety instructions in this document and all other related documentation.
NOTE: Gaskets are glued to the console and pedestal around the display
opening. Do not damage or remove these gaskets as that will destroy the
dust-tight integrity of the enclosure and void agency approvals.
NOTE: Both the short and long power cable harnesses are included in the touch
screen replacement kit. Use the short power cable for pedestal system
installations and use the long power cable for console system installations.
1. Power off the iControl 2 system.
2. Disconnect the blue video cable, touch screen serial cable, and power cable
harness from the back of the old touch screen unit and set aside.
See Figure 1.
3. Remove the mounting nuts (3) from the mounting clamp (2) and set aside.
4. Install the replacement touch screen (1) onto the mounting clamp (2) and
tighten all mounting nuts (3) to 2.5 NSm (22 in-lbs).
1
2
3
2. Mounting clamp
Instruction Sheet
P/N 1609016-01
r
2 touch screen display monitor.

Console Installation

3. Mounting nut
2
3
Part 1609016-01