LG 43SH7PE Owner's Manual page 109

85. Fail Over USB Input (Command: s n, 0a)
Selects a USB status for fail over.
Transmission
[s][n][ ][Set ID][ ][0a][ ][Data] [Cr]
Data 00: Off
01: Picture
02: Photos
Acknowledgment
[n][ ][Set ID][ ][OK/NG][0a][Data] [x]
86. Fan Failure Check (Command: d w)
Check the fan malfunction.
Transmission
[d][w][ ][Set ID][ ][Data][Cr]
Data FF: Read status
Acknowledgment
[w][ ][Set ID][ ][OK/NG][Data][x]
Data 00: Fan failure
01: Fan normal
* This feature may not be available for all models.
87. Network Setting (Command: s n, 80 or 81 or 82)
Configures network and DNS settings.
Transmission
[s][n][ ][Set ID][ ][Data1][ ][Data2][ ]
[Data3][ ][Data4][ ][Data5][Cr]
Data1 80: Configures/views the temporary IP mode
(Auto/Manual), subnet mask, and gateway.
81: Configures/views the temporary DNS address.
82: Saves temporary settings and views
information about the current network.
* If Data1 is 80,
Data2 00: Auto
01: Manual
FF: Views the temporary IP mode (Auto/Manual),
subnet mask, and gateway.
** If Data2 is 01 (Manual),
Data3: Manual IP address
Data4: Subnet mask address
Data5: Gateway address
* If Data1 is 81,
Data2 DNS address
FF: Displays the temporary DNS address.
* If Data1 is 82,
Data2 80: Applies the temporary IP mode (Auto/
Manual), subnet mask, and gateway.
81: Applies the temporary DNS address
FF: Information on the current network (IP, subnet
gateway and DNS)
*** An example of settings,
1. Auto: sn 01 80 00
2. Manual: sn 01 80 01 010177223241 255255254000
010177222001(IP:10.177.223.241, subnet:
255.255.254.0, gateway: 10.177.222.1)
3. Network read: sn 01 80 ff
4. DNS setting: sn 01 81 156147035018 (DNS:
156.147.35.18)
5. Applying the settings: sn 01 82 80 (applies the saved
* Each IP address contains 12 decimal digits.
Acknowledgment
[n][ ][Set ID][ ][OK/NG][Data1][Data][x]
* This feature is available only for wired networks.
* This feature may not be available for all models.
IP mode (auto/manual), subnet
mask, and gateway), sn 01 82 81
(applies the saved DSN)
59