Setting The Clock - JVC RC-EZ38S Instructions Manual

SETTING THE CLOCK

Before operating the unit any further, first set the clock
built in this unit.
There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 2 again.
1 Press STANDBY/ON
The clock is displayed.
2 Press and hold CLOCK.
The hour digits start flashing.
3 Press 4 or ¢ to adjust the hour.
4 Press CLOCK.
The minute digits start flashing.
5 Press 4 or ¢ to adjust the minutes.
6 Press CLOCK.
Note:
If there is a power failure, the clock loses the setting.
The clock indication will keep flashing until you set the
clock again.
To show the clock when the unit is on
Press CLOCK.
Each time you press the button, the display changes the
clock indication and the normal indication alternately.
To change 12-hour indication or 24-hour
indication
The clock uses 24-hour indication as default.
You can change the clock to 12-hour indication.
1 2, 4, 6 3, 5
to turn on.
3, 5 1
1 Press MENU/ENTER while in clock mode.
CLOCK SET
MODE:12/24
2 Press 4 or ¢ to select 12-hour indication
or 24-hour indication.
3 Press MENU/FM MODE twice.
The display is set.
(AM12:00 is Midnight, and PM12:00 is Noon.)
To set the sleep timer
When the time you specify elapses, the system will be
turned off automatically.
On the remote control only.
1 Press SLEEP.
Flashing "SLEEP 10" and "
005
00:01
SLEEP
Each time you press the SLEEP button, the time length
changes as follows:
10=20=30=60=90=120=OFF=(back to the
beginning)
2 Wait for a few seconds.
Only the " " is displayed, and the sleep timer is set.
S
To Confirm the Sleep Time:
Press SLEEP once while the sleep timer is set.
To Cancel the Sleep Timer Setting:
Press SLEEP repeatedly until "SLEEP OFF" appears.
Note:
The sleep timer will also be cancelled when the power is
turned off.
3, 5
STANDBY /
MENU/
ON /
TAPE FM MODE
TUNER/
CD USB
BAND
STOP/
ENTER
PROGRAM /
RANDOM REPEAT PRESET
MUTING SLEEP EQ
1 2 3
4 5 6
7 8
VOL
9 0
REMOTE CONTROL UNIT
RM-SRCEZ38 A
" are displayed.
S
10
S
7