IMER COMBI 200 VA Operating, Maintenance, Spare Parts Manual page 11

The power lines must be laid to prevent any possible damage.
Ensure that the electrical connection is protected against the risk of wa-
ter penetration in connectors. Use exclusively connectors and couplings
equipped with water spray protection.
Never use inadequate or makeshift electrical lines or cables without
earthing; if in doubt consult a specialised technician.
Repairs to the electrical circuit must be performed exclusively by specia-
lised personnel. Disconnect the machine from the power supply before
performing maintenance or repairs.
Note that this machine has been designed to ensure optimal performan-
ce and maximum safety: however the operator must also guarantee this
level of safety by paying special attention to the machine throughout all
work phases.
The Combi 200 VA has been constructed taking into account current
harmonised European safety standards.
According to machine directive 98/37/EEC all safety devices have been
installed with the aim of safeguarding the operator.
and protections that prevent access to moving or dangerous parts.
envisaged to protect the operator (maintenance engineers, technicians
and others) from possible accidents cause by electrical discharge or
moving mechanical parts.
way is strictly prohibited.
IMER INTERNATIONAL S.p.A.
COMBI 200 VA
The machine must be placed on a smooth surface that is at least as
large as the tank, with the saw on the relative stand.
In the event of moving the saw, take care to secure the head by means
The stand is supplied disassembled. Firstly, join the two parts of each
leg making sure that the inner and outer holes are aligned. Join the two
allow rotation of the legs.
- The Combi 200 VA saw weights 33 Kg and can be moved by means of
-
The side roller table is supplied with side supports already assembled.
-
inside the proper seats housed alongside the saw up to the stop. Now
Then tighten the nut.
-
-
-
-
-
-
11
GB
-
-