Advertisement
Quick Links
COMBl250l1000 VA
I
SAWING MACHINE
'188174'0000704062
OPERATING, MAINTENANCE, SPARE pARTS MANUAL
1IIIIIIIIIIIIIUlI\li~1l11l111111111111111111
MODEL NUMBER:
SERIAL NUMBER:
WEIGHT
LBS;.
1188174
0000704062
132
.'
.
"
~:
'.
IMER
U.S.A. Inc.
Toll Free: 800275.5463
2007/09 - R02
IMERWEST
www.imerusa.com
IMER EAST
3654, Enterprise Avenue
info@imerusa.com
221 Westha!T1plon Place
Cod. 3227118
Hayward, CA 94545
Capitol Heights, MD 20743
Ph. 510.670.7970
Ph. 301.336.3700
Fax 510.783.4255
Fax 301.336.6687
Advertisement
Need help?
Do you have a question about the COMBl 250/1000 VA and is the answer not in the manual?
Questions and answers
My maintenance for the slide on my 250/1000 VA
The maintenance procedure for the IMER COMBl 250/1000 VA slide includes the following steps:
1. Turn Off and Disconnect Power: Before performing any maintenance, turn off the machine using the main switch and disconnect it from the power supply to prevent accidental start-up.
2. Check and Clean Contacts: Ensure that the contacts of the power plug and plug-switch assembly are efficient. If oxidation is detected, clean immediately.
3. Inspect and Maintain Guards: The machine is equipped with fixed guards and protective covers secured by screws. These must not be removed or modified, as they protect the operator from moving parts and electrical hazards.
4. Lubrication and Cleaning: Regularly clean and lubricate the slide components to ensure smooth operation.
5. Check for Wear and Damage: Inspect the slide for any signs of wear or damage and replace any defective parts as necessary.
6. Ensure Proper Water Tank Levels: Keep the water tank filled to the maximum level (approximately 40 liters) for proper cooling and dust control.
Unauthorized modifications or improper maintenance may lead to machine failure and safety risks.
This answer is automatically generated
Trying to replace plunge cut spring. How do I get the bar with the nuts on either end that holds the spring out