Advertisement
COMPONENTS
The following is a description of the IDP-Relay-6 mount-
ing framework:
• One or two IDP-Relay-6 modules can be installed in a
IDP-ACB cabinet
The IDP-ACB cabinet has a built-in chassis that will ac-
commodate one or two IDP-Relay-6 modules.
Figure 1: IDP-ACB Cabinet
The front IDP-Relay-6 module positions of each chassis
are offset below the rear IDP-Relay-6 module positions
so that all of the status indicators are visible. For cabinet
dimensions refer to IDP-ACB instruction manual.
INSTALLATION STEPS
1. Cabinet Mounting
In a clean, dry area, mount the backbox using the four
holes provided in the back surface of the cabinet.
Figure 2: Typical mounting hole locations
2. Module Installation
There are two methods for installing a module in the
rear position of a chassis. Method one is for installa-
tion of a rear module only, when no module will be in-
stalled in front of it. Refer to Figure 3 for instructions.
Method two is for installation of a rear module when
another module will be installed in the chassis position
in front of it. Refer to Figures 4a and 4b for method
two. All necessary screws and standoffs are supplied
with the modules.
K200-15-00
Figure 3: Installation of rear module only, method one
Step 1: Insert the bottom of the IDP-Relay-6 module
Step 2: Carefully swing the upper edge of the board
C0234-03
Step 3: Align two 4-40 screws with the two standoffs
Step 4: Address and wire the modules according to the
The steps in Figures 4a and 4b describe and illustrate mod-
ule installation when the rear chassis position and the posi-
tion in front of it will be filled. Front position installation
is possible only if the rear position is filled with a module.
Backbox
Mounting
Holes
C0235-00
Figure 4a: Installation of IDP-Relay-6 module in a
Step 1: Insert the bottom edge of the IDP-Relay-6
Step 2: Carefully swing the bottom edge of the board
Step 3: Align the long standoff with the short standoff
2
2
1
down into a rear slot on the chassis.
back towards the back of the chassis until it
touches the two standoffs.
and tighten.
instructions in this manual.
1
rear chassis position, method two
module down into a rear slot of the chassis.
towards the back of the board until it touches the
short standoff attached to the chassis.
and tighten.
3
C0249-00
C0244-00
I56-2732-003
Advertisement
