MWD WHEELCHAIRS
REPLACING STABILIZER
CYLINDER SPRING (FIGURE 9)
NOTE: Stabilizer springs are only on wheelchair mod-
els built before 7/1/1999.
Locknut
Stabilizer
Spring
FIGURE 9 - REPLACING STABILIZER CYLINDER SPRING
All manuals and user guides at all-guides.com
ADJUSTING WEIGHT DISTRIBUTION
(FIGURE 10)
NOTE: The seat mount plates and seat support brackets
allow seat frame to be repositioned along the base frame.
NOTE: The position of the seat support brackets is factory
set at 5-1/2-inches from the front end of the base frame.
Use the following chart as a starting point.
NOTE: Following the above chart will put 85-90% of the
total weight of the chair and user over the large wheels.
However, these settings may not be the most desirable in
terms of maneuverability and comfort for the user.
Adjustment for Optimum Performance
Base Frame
Mounting
Screw
Adjustment
Barrel
Jam Nut
Adjustment
Nut
Spring
Retainer
Stabilizer
Rod
75
WARNING
DO NOT adjust seat beyond limit stops.
PROCEDURE 15
M
W
D
W
H
E
E
L
C
H
A
I
R
S