Procedure 17 - Fwd Wheelchairs; Removing/Installing Rear Shroud; Removing/Installing Front Shroud; Removing/Installing Side Shroud Assembly - Invacare Storm Series Service Manual

FWD WHEELCHAIRS
This Procedure includes the following:

Removing/Installing Rear Shroud

Removing/Installing Front Shroud

Removing/Installing Side Shroud Assembly

Removing/Installing Counterweight
Replacing Group 24 Battery Box Sub-Frame
Removing/Installing Shocks
Shock Spring Replacement
Tie Rod Replacement
Removing/Installing Gearbox
Sensor Cable Assembly Replacement
Replacing Suspension Arm
Removing/Installing The Wiring Harness
Adjusting Weight Distribution
WARNING
After ANY adjustments, repair or service
and BEFORE use, make sure that all at-
taching hardware is tightened securely -
otherwise injury or damage may result.
REMOVING/INSTALLING REAR
SHROUD (FIGURE 1)
Removing
1. Turn the two (2) wing nuts COUNTERCLOCKWISE
and lift up on the rear shroud.
Installing
1. Position the rear shroud on the wheelchair frame align-
ing the two (2) wing nuts with the mounting brackets.
2. Turn the two (2) wing nuts CLOCKWISE to secure
rear shroud in place.
Wing
Nut
Rear
Shroud
FIGURE 1 - REMOVING/INSTALLING REAR
SHROUD
All manuals and user guides at all-guides.com
Wing
Nut
REMOVING/INSTALLING FRONT
SHROUD (FIGURE 2)
Removing
1. Turn the two (2) wing nuts on the TOP of the front
shroud COUNTERCLOCKWISE.
2. Turn the wing nut on the BOTTOM of the front shroud
COUNTERCLOCKWISE and lift up on the front
shroud.
Installing
1. Position the front shroud on the wheelchair frame.
2. Align the wing nut on the BOTTOM of the front shroud
with the mounting bracket on the wheelchair frame.
3. Align the two (2) wing nuts on the TOP of the front
shroud with the mounting holes in the wheelchair frame.
4. Turn the wing nut on the BOTTOM of the front shroud
CLOCKWISE to secure front shroud in place.
5. Turn the two (2) wing nuts on the TOP of the front
shroud CLOCKWISE to secure front shroud in place.
Mounting
Bracket
Wing Nut
FIGURE 2 - REMOVING/INSTALLING FRONT
SHROUD
REMOVING/INSTALLING SIDE
SHROUD ASSEMBLY (FIGURE 3)
Removing
1. Remove the rear shroud. Refer to REMOVING/INSTALL-
ING REAR SHROUD in this procedure of the manual.
2. Remove the drive wheel from the wheelchair. Refer
to REMOVING/INSTALLING DRIVE WHEEL in PRO-
CEDURE 12 of this manual.
91
PROCEDURE 17
Wing Nut
Front
Shroud
F
W
D
W
H
E
E
L
C
H
A
I
R
S