Installation; Unpacking And Setting-Up The Printer; Install The Printer Driver; Install The Winsign Software - Partex MK10 Quick Start Manual

1. Installation

1.1 Unpacking and Setting-up the Printer

1. Lift the label printer out of the box via the straps..
2. Check printer for damage which may have occurred during transport.
3. Set up printer on a level surface..
4. Remove foam transportation safeguards near the printhead.
5. Check delivery for completeness.
Contents of delivery: (MK10-KIT1)
• Printer
• Power cable
• Cutting unit
• Printer cable USB
• Ribbon
• Drivers on CD
• Software WinSign on CD
Read the manual for the printer.

1.2 Install the printer driver.

Put the CD with drivers in your computer. Follow the instructions on your computer
screen.
Choose the CAB A4+M/300 printer

1.3 Install the WinSign software.

Put the CD with the WinSign software in your computer. Follow the instructions on
your computer screen.
Read the user manual for WinSign.
You need to type in some information when you start WinSign for the first time. This
message box will not appear after that.
2009-11-27
QUICK START MK10
PARTEX MARKING SYSTEMS 3