TANDBERG 550 MXP User Manual page 20

D1372102_T550_MXP_User_Manual
3. ISDN cables

Connect the ISDN cables to the ISDN sockets (S/T-interface) provided by the service
provider. The main number will be the number associated with the socket to which
ISDN cable number 1 is connected.
Note! Some systems and software versions do not support four ISDN lines.
North America: The system does not have a built-in network terminator. If the wall socket
provides an ISDN U-interface, an NT1 between the system and the ISDN line is needed, see
Appendix 10.
Note! Write down the numbers associated with each of the ISDN lines. They are needed for
configuring the system.
Note! Connecting to the switched 56 network: When connecting to the switched 56 network
one of the BRI interfaces on the system may be used. Please refer to
information.
4. Power cable

Connect the power cable from the system's power connector to an electrical distribution
socket.
5a. LAN cable

To use the system on LAN, connect a LAN cable from the 'Ethernet' connector on the
system to the LAN.
5b. Wireless LAN - Insert PC Card

Remove the "dummy" card by pressing the 'Eject' button next to the slot.

Insert the Wireless LAN PC Card.
10
Appendix 9 for further