Assembly Instructions; Handle Bar - Ecotric Folding Fat Bike Assembly Instructions & Owner's Manual

ASSEMBLY INSTRUCTIONS

Your bike has been pre-assembled and requires only a few simple steps
For Handle bar
to get it ready for you to ride:
1. Carefully remove your bike from the carton and gently rest it in place with the
kickstand down.
2. Remove all of the inside cardboard protection and bubble wrap on the bike.
3. Please locate and set aside the kit box containing the battery charger, pedals, and
tool kit etc.
4. Place the handle bar on the stem, and tighten four bolts with 5mm hexagonal
spanner (Figure 1), Position the handlebars to your desired comfort level.
5. Once the handlebars are aligned and the top bolt is slightly secured, firmly tighten
the 2 side bolts on the stem with 6mm hexagonal spanner(Figure 3). After tightening
the 2 side bolts, firmly tighten the top bolt with 5mm hexagonal spanner(Figure 2).
After all 3 bolts have been securely fastened, make sure there is no play in the
headset.
Do not over tighten the stem bolt. Over tightening the stem bolt can damage the
WARNING:
steering system and cause loss of control.
Figure 1
Figure 2 Figure 3
5