Rubber - Sauder 421191 Instruction Booklet

Step 22
Slide a SHELF MOLDING* (I) onto the notched edge of one of the SHELVES (E).
å
Repeat this step for the remaining SHELVES (E) and SHELF MOLDINGS (I).
å
Push the RUBBER SLEEVES (2R) over the METAL PINS (1R). Insert the METAL PINS into the hole locations of your choice
å
in the ENDS (A and B) and UPRIGHT (C). Set the ADJUSTABLE SHELVES (E) onto the METAL PINS.
*U.S. Patent No. 5,499,886
å
Notched edge
Slide the SHELF MOLDING (I)
onto the notched edge.
www.sauder.com/service
These surfaces should be even.
E
I
The groove is
closer to this edge.
1R
(20 used)
E
B
E
2R
421191
E
C
A
E
E
Page 27