Sauder 421191 Instruction Booklet page 26

Step 21
If your unit teeters and one of the LEVELERS is not touching the fl oor, turn the LEVELER out of the LEG until it touches the
å
fl oor. Slide the DOOR over to the left side of your unit.
Diagram #1 : The gap between the DOOR and the side of your unit should be constant from top to bottom. If it is not, then
å
make adjustments below.
Diagram #2: If your door has a larger gap near the bottom, then turn the left front LEVELER out of the LEG a couple of
å
turns. You may need to turn the LEVELER a couple of turns again to get your DOOR adjusted as shown in diagram #1.
Diagram #3: If your door has a larger gap near the bottom, then turn the right front LEVELER out of the LEG a couple of
å
turns. You may need to turn the LEVELER a couple of turns again to get your DOOR adjusted as shown in diagram #1.
If further door adjustments are needed, loosen the SCREWS in the WHEEL SUPPORTS a 1/4 of a turn, make any needed
å
adjustments, and tighten the SCREWS as shown in the enlarge view.
The gap
between
the DOOR
and the unit
should be
constant from
top to bottom.
Page 26
Loosen these SCREWS
a 1/4 of a turn, make
adjustments, and tighten.
Diagram #1
To eliminate this large
gap, turn the front left
LEVELER out.
Diagram #2
421191
To eliminate this large
gap, turn the front
right LEVELER out.
Diagram #3
www.sauder.com/service