Sauder 421191 Instruction Booklet page 15

Step Step 10
Fasten seven METAL BRACKETS (4G) to the ENDS (A and B),
å
BOTTOM (D), and TOP (N). Use seven BLACK 9/16" LARGE
HEAD SCREWS (1S).
Fasten the SKIRT (G) to the BOTTOM (D). Use three BLACK
å
9/16" LARGE HEAD SCREWS (1S) through the METAL
BRACKETS and into the SKIRT.
NOTE: There are no pre-drilled holes in the SKIRT. The
å
SCREWS will tighten into the groove.
Fasten the VALANCE (F) to the ENDS (A and B) and TOP (N).
å
Use four BLACK 9/16" LARGE HEAD SCREWS (1S) through
the METAL BRACKETS and into the VALANCE.
NOTE: The SCREWS will tighten into the groove.
å
Surface with holes
The holes are
closer to this edge.
www.sauder.com/service
F
N
B
The groove is
closer to this edge.
BLACK 9/16" LARGE HEAD SCREW
A
421191
1S
(14 used in this step)
4G
G
D
4G
Page 15