Initial Setup; Using An Hp 8340/41 Rf Source; Connecting The Waveguide - HP 85325A Operating And Service Manual

Figure 1-1
NOTE
Using an HP 8340/41
RF Source
Connecting the
Waveguide

Initial Setup

Connect the equipment as shown in Figure 1-1.
Initial Setup
It is important that you connect the mm-wave head to the RF source (as
shown in Figure 1-1) before using the procedures in this manual. The
mm-wave head configures the RF source so it will accept mm-wave band
start and stop frequency commands from the receiver.
If you are using an HP 8340/41 as an RF source, refer to Appendix A for
setup information.
When connecting the waveguide, refer to Appendix B, "Connecting the
Waveguide Properly." Use the waveguide accessory hardware kit when
connecting the waveguide components.
HP 85325A Operating and Service Manual 1-3
Installation
Initial Setup