Receiver Settings; Setting Up The Receiver - HP 85325A Operating And Service Manual

NOTE
Setting Up the
Receiver
NOTE

Receiver Settings

indicate a front-panel key or on a computer key board.
[[Brackets]
indicate a display softkey selection.
{Braces}
1. Turn ON the RF source. Make sure it is set to HP-IB address 19.
2. Turn ON the LO source. Make sure it is set to HP-IB address 18.
3. Turn ON the following components in the order shown:
a. RF power amplifier (if used)
b. HP 85309A
c. Receiver
If your LO source is an HP 8350, it is normal for
CAUTION, NO IF FOUND
CAUTION: SOURCE 1 FAILURE
to appear on the screen at this time. The message will go away later, when
you connect the reference mixer.
4. Press:
[USER PRESET]
[SYSTEM]
{HPIB ADDRESSES}
(sets address of the LO source)
{SOURCE #2} [1][8] [x1]
5. If using an HP 8510, press:
6. If using an HP 8530, press:
Press:
[RECALL] {MORE} {FACTORY PRESET}
Press:
[SYSTEM] {MORE} {SYSTEM PHASELOCK}
a. If using a synthesized LO, select
b. If using an HP 8350 source, select
or
RF UNLOCKED
{TEST SET} [3][1] [x1]
{CONVERTER} {SET ADDRESS} [3][1] [x1]
{LOCK TYPE: NONE}
{LOCK TYPE: EXTERNAL}
HP 85325A Operating and Service Manual 1-5
Installation
Receiver Settings
.
.