Grandstream Networks DP752 Administration Manual page 72

Custom Time Zone Settings
Custom Time Zones
UTC Offset
Second Offset
DST Type
Start & End Times
Time zone settings by
week
Time zone settings by
day
Manual Time Settings
Manual Time
Year / Month / Day
Hour : Minute
Syslog
Syslog Protocol
Syslog Server
Enable or disable customized time zone. Default is Disabled.
Offset is negative for time zone following UTC and positive for time zone
leading UTC (-12 to +14). Default is 0.
Offset for second time zone. Offset is negative for time zone following UTC and
positive for time zone leading UTC (-12 to +14). Default is 0.
Set Daylight Savings Time by day or by week. Default is by week.
Starting and ending times for the time zone.
Default Start is 2:0 ; Default End is 2:0.
Start & End Months: Starting and ending months for the time zone.
-
Default Start is April; Default End is September.
Start & End settings by week : Starting and ending settings by week for
-
the time zone.
Default Start is Sunday, Week 1 ; Default End is Sunday, Week1.
- Start & End settings by day:
Starting and ending settings by day (0-365) for the time zone.
Default Start is 1 ; Default End is 1.
Disables/Enables manual time settings. Default is Disabled.
Set the Year (2016-2037), Month (1-12) and Day (1-31) manually.
Enter hour (0-23), Minute (0-59) manually.
Default UDP. While SSH/TLS allows sending syslog through secured TLS
protocol to syslog server. Note: CA verification is required
Sets IP address or URL of system log server. The server collects system log
information from the base station.
User may configure the Syslog port by adding it after the Syslog Server
address. When configured, the Syslog messages will be sent to this port
instead of the default syslog port. Default is 514.
DP752/DP730/DP722 Administration Guide
Version 1.0.11.4
P a g e | 72