internet.
Configuration procedure:
Step 1
Choose Administration, and move to the WAN Parameters module to enter the
configuration page.
Step 2
Set Clone MAC Address to Clone Local Host MAC.
Step 3
Click OK at the bottom of the page.
---End
Scenario 2: The computer used to manage the router is not the computer that used to access the
internet. And you need to get the MAC address of the computer that can access the internet.
Configuration procedure:
Step 1
Choose Administration, and move to WAN Parameters module to enter the configuration
page.
Step 2
Set Clone MAC Address to Manual.
Step 3
Enter the MAC address of the computer that can access the internet in the format of
xx:xx:xx:xx:xx:xx.
Step 4
Click OK at the bottom of the page.
---End
WAN Speed
WAN speed specifies the speed of the WAN port. By default, the throughput of the WAN port is
Auto-negotiation. Change the setting only when necessary. If the router cannot access the internet
after you set up it correctly with a 10 Mbps upstream device, you can change WAN speed to 10
Mbps auto-negotiation to achieve negotiation.
76