Appendix H - Talkswitch And Power Interruptions - Talkswitch 48-CVA Installation And User Manual

Appendix H - TalkSwitch and Power Interruptions

T T a a l l k k S S w w i i t t c c h h s s e e t t t t i i n n g g s s a a n n d d c c o o n n f f i i g g u u r r a a t t i i o o n n s s : :
In the event of a power failure, your TalkSwitch settings and configurations will not
be lost.
TalkSwitch's feature settings (configuration) are stored in an EEPROM. An EEPROM
is a form of non-volatile memory. Non-volatile memory means that your feature
settings (configurations) remain in TalkSwitch's memory despite interruptions in the
power supply.
C C a a l l l l i i n n g g F F e e a a t t u u r r e e s s : :
In the event of a power failure, no TalkSwitch features or capabilities (including
VoIP) will be available other than:
• Local Extension, 114, 124, 134 and 144 can make or receive calls on Line 1 of
their respective units
In the event of a power return, all TalkSwitch features and capabilities will be re-
established.
M M o o d d e e S S c c h h e e d d u u l l i i n n g g a a n n d d P P o o w w e e r r I I n n t t e e r r r r u u p p t t i i o o n n s s : :
When the power supply to TalkSwitch has been interrupted, TalkSwitch's internal
clock will continue to run for up to 12 hours. If you have enabled TalkSwitch's
Automatic Mode Scheduling feature and it has been longer than 12 hours,
TalkSwitch will not function properly until the internal clock is reset via a Caller ID
call or with the TalkSwitch configuration software. When power is restored to
TalkSwitch, TalkSwitch will check the time and determine the mode it should be in
according to the configuration and set itself to that mode.
To check the current mode of operation, dial at a Local Extension to enter
command mode, then enter a password if required. Next, dial 30 then . TalkSwitch
will report the current mode.
Appendices 135