Table of Contents
Advertisement
Problem: The auditioning source re-
sponds to control commands,
but the system produces no
output signal.
Cause:
Loudspeaker outputs switched
off; 'A' or 'B' not glowing on the
screen.
Remedy: Press
handset to switch on the speakers.
Problem: Loud hum from the speakers
when playing back through
TAPE or AUX/TV.
Cause:
Poor contact of a Cinch plug or a
faulty Cinch lead.
Remedy: Please check all connections and
cables.
Problem: The unit switches off repea-
tedly at fairly high volume le-
vels.
Cause1:
Overheating due to heat build-
up.
Remedy:
Set up the unit in a position whe-
re there is an unobstructed flow
of cooling air.
Cause2:
Overheating due to insufficient
loudspeaker impedance.
Remedy:
Use only loudspeakers with an
impedance of at least 4 Ω (DIN
normalised value); this cor-
responds to a minimum impe-
dance of > 3.2 Ω.
the
appropriate
or
on the RC
Problem:
Cause1:
button
Remedy:
Cause2:
Remedy:
Problem:
Cause:
Remedy:
54
Tuner section
The RDS station name does
not appear on the screen.
The station is not broadcasting
RDS information, or is not cor-
rectly tuned in.
Tune in the station so that the
tuning indicator is in the centre
position.
The tuner is picking up interfer-
ence on the same frequency, or
the signal strength is too low.
Select only those stations which
can be received with good sig-
nal strength, devoid of back-
ground hiss and interference.
When you switch presets the
RDS station name does not
appear correctly, or only after
a long wait.
The name was not picked up
correctly during the preset stor-
ing procedure, or the station is
broadcasting the station name as
a running script, contrary to the
RDS norms.
Call up the preset and wait until
the station name appears cor-
rectly on the screen, then store it
manually.
Hide quick links:
Advertisement
Table of Contents
