Volume Control; Speaker Outputs; Loudness / Low Bass Equalisation - T+A Elektroakustik K1 CD-RECEIVER Operating Instructions Manual

VOLUME CONTROL

Every
VOLUME rocker the volume level
is reduced (
(
If you hold the
pressed in for more than one se-
cond, the volume alters continu-
ously until you release the rocker
again.
Every time you alter the volume,
the screen briefly displays the cur-
rent value.

SPEAKER OUTPUTS

This button switches the speaker
output
If you press one of the buttons, the
new status is shown briefly on the
alpha-numeric screen, e.g.:
'SP A ON' or 'SP A OFF'
The current
loudspeaker
displayed continuously on the
screen in the form of a letter 'A' or
'B'.
Note:
When you switch the system on the speaker
outputs are initially switched off. After a
short standard delay period speaker output 'A'
always switches itself on.
time you press
) or increased
) by 1.25 dB.
A and/or B on or off.
status of
outputs is

LOUDNESS / LOW BASS EQUALISATION

the
   
rocker
SELECTING THE AUDITIONING SOURCE
You select the machine you want to listen to
by pressing one of the source buttons. The
signal from this source is then reproduced by
the system.
At any one time you can only remote-control
the machine which is currently selected as
the auditioning source. The auditioning sour-
ces are selected using the following buttons
on the remote control handset:
 internal CD player

 
the
also
Note:
When you switch sources the screen shows
the newly selected auditioning source briefly.
It then reverts to a standard machine-specific
display.
13
Short keypress:
Switches LOUDNESS On / Off.
Long keypress (approx. 1 sec.):
Switcess low bass enhancement
On / Off.
internal tuner
source device connected to the pre-
amplifier input AUX/TV
recording machine connected to
the pre-amplifier input TAPE