Multi-Room Sound System - T+A Elektroakustik K1 CD-RECEIVER Operating Instructions Manual

Multi-room sound system (MULTIROOM)
If you decide to use the K1 as the basis of a
sound system serving more than one room,
we recommend the following configuration
(see appropriate wiring diagram):
• The system is located in the main listening
room (Room A). The speakers connected
to the loudspeaker output
same room.
• In the adjacent room (Room B) is a pair of
speakers connected to the loudspeaker
output B. If you want the facility to re-
mote-control the system from Room B,
you will need to install an E 2000 remote
control receiver in this second room, con-
nected to the remote control input RC IN
on the K1.
• The system needs to be set to 'VOL A/B'
mode (see amplifier special function
'SETUP').
• If you switch on the K1 next time using
the remote control handset, only the
loudspeakers in the user's room will be
switched on; the other pair of speakers
will stay silent. However, it is still possible
to switch on in the usual way.
• If you stay in the neighbouring room you
can only alter the volume in that room;
from the main room you can only adjust
the volume in the main room. These vo-
lume values are independent of each other
over a broad range, but if the volume le-
vels differ widely, a change in value in
one room may affect the volume in the o-
ther.
A are in the
48
Note:
The cable from the separate remote control
receiver can be extended up to a total
length of 50 metres.
If you need to extend the cable we rec-
ommend the use of twin-core screened ca-
ble with a conductor capacitance of
150 pF/m or less.
For greater cable lengths you will need to
use lower capacitance cable.
You cannot access the K1 system menus
from the secondary room.