Krups Espresso Automatic EA88 Series Manual page 21

MALFUNCTION
There is water under the
appliance.
The milk or water is not
flowing correctly into the
cup or cups.
Traces of milk are present
in an Americano or Hot
Water recipe.
When you turn off the
appliance, hot water will
come out of the coffee
nozzles and the One
Touch Cappuccino block.
After emptying the
coffee grounds collector
and cleaning the coffee
drawer, the warning
message is still displayed.
The coffee comes out too
slowly.
After filling the water tank,
the warning message
remains on the screen.
The grind setting button is
difficult to turn.
The espresso or coffee is
not hot enough.
The coffee is too clear or
not coarse enough.
No coffee is coming out of
the appliance.
There was a power outage
during the cycle.
Danger: Only a qualified technician is authorized to perform repairs on the power cord
and the electrical network. If this instruction is not followed, you are at risk of
death due to electric shock! Never use an appliance that is visibly damaged!
CORRECTIVE MEASURES
Before lifting off the tank, wait for 15 seconds after the coffee has run
through so that the appliance finishes its cycle correctly.
Check that the drip tray is correctly positioned on the appliance, it
must always be in place, even when your appliance is not being used.
Check that the drip tray is not full.
The drip tray must not be removed during a cycle.
Check that the milk output lid is correctly positioned Fig. 25
Perform an automatic rinsing cycle, or disassemble and clean the
accessory, before launching the recipe.
According to the type of recipe prepared, the appliance can carry out
an automatic rinsing operation when it is turned off. This cycle lasts
only for a few seconds and stops automatically after it is done.
Correctly put back into place the coffee drawer and the coffee
grounds collector, follow the instructions on the screen.
Wait for at least 8 seconds before putting them back in.
When in operation, turn the grind setting knob to the right for coarser
coffee grounds (this can depend on the type of coffee used).
Perform one or several rinse cycles. Launch a clean program (see
"Coffee circuit automatic cleaning program" p.16).
Change the Claris Aqua Filter cartridge (see "Filter installation" p.11).
Check that the tank is correctly positioned in the appliance. Check
and unblock the float if necessary. The float at the bottom of the tank
should move freely.
Only change the grinding setting when in operation.
Rinse the coffee circuit before starting to prepare your coffee.
Increase the temperature of the coffee in the Settings menu. Heat the
cup by rinsing with hot water before starting the preparation.
Do not use oily, caramelized or flavored coffees.
Check that the bean tank contains coffee and that it is working properly.
Reduce the volume of the preparation, increase the strength of the
preparation.
When in operation, turn the grind button to the left for finer coffee
grounds.
Prepare your coffee in two cycles using the two cup function.
An incident has been detected during the preparation.
The appliance has restarted automatically and is now ready for a new
cycle.
The appliance restarts automatically when reconnected.
19