Kenmore Trio Series Use & Care Manual page 5

HOW TO REPLACE THE
HINGES, DOORS AND
DRAWER
1. Install stabilizing brackets with _8"hex
head driver.
2. Replace toe grille and bottom bracket
covers.
>_Snap bottom portion of toe
grille into place first. Press
down on top part of grille until
top portion snaps into place.
3. Pull both rails out to furl extension.
5. With drawer puffedout to full
extension, insert lower basket by
aligning tabs on both side of lower
basket with notches in rail assembly.
6. Slide upper basket into refrigerator.
Make sure that rea_" o f basket hooks
behind rail catch.
7.
,
9.
10.
11.
12.
Install center hinges with Phillips
screws.
>- Replace door closure on the dght
side. Door closure cannot be
used on the left side.
Place hinge side of refrigerator door
on center hinge pin.
While holding refrigerator door
upright, tighten door top hinge with
'A,"hex head driver.
Repeat steps 8 and 9 to install
second door.
Reconnect wire harness on left side
door.
,Replacetop hinge coverson both
hinges.
4. Hook door supports into rail tabs, as
illustrated, and lower door into final
position.
4