Symbol P370 Product Reference Manual page 193

Error Code
015 RF Communication
Error
016 RF Communication
Error
017 RF Communication
Error
018 MCL-Link Error
020 RF Communication
Error
021 Memory Allocation Error For repeated occurrence contact Customer Service.
024 RF Communication
Error
247 MCL-Link Error
249 MCL-Link Error
253 MCL-Link Error
Note: For users developing applications, these error codes will not be shown on the
display but are reported in System Variable 97 immediately after the execution of
the offending command (SO, SI, NO or NI).
Table D-2. Error Codes
Type
Scanner is out of range, not properly paired to a base
or the base may have lost power.
The base to which the scanner is paired has been
paired with another scanner.
Scanner is out of range.
A Synapse cable cannot communicate with MCL-Link.
Reconnect to the host using an RS-232 cable and then
cycle power (power off then on) to the base.
Previous RF transmission not yet complete.
The base is not responding. Cycle power (power off
then on) to the base.
MCL-Link responded with a busy message.
MCL-Link rejected the command.
MCL-Link or 123Scan did not respond. The base may
not be properly connected to the host. make sure the
RS-232 cable is properly connected and the base is
receiving power. If the problem persists, cycle power
(power off then on) to the base.
Messages and Error Codes
Description
D-3