Table of Contents
Advertisement
e CALL button
When this button is pressed, the red tally lamp of the RCP-
1500 series Remote Control Panel or the MSU-1000 series
Master Setup Unit will light. Use to call the operator of the RCP
or MSU.
f CAMERA POWER switch
CCU: Power is supplied from the camera control unit.
EXT: Power is supplied through the DC IN connector.
Operation panel
a
b
h
PGM1 control
INCOM level control
MIC switch
a ASSIGN (assignable) switch 1
You can assign a function using the menu displayed on the
viewfinder screen.
b RET 1 (return video 1) button and select switch
Use to switch between the video signal of the unit and the
return video signal. The video signal is displayed on the
viewfinder screen.
c DISPLAY switch
The functions of the DISPLAY switch are as follows: It
functions the same as the DISPLAY switch (page 5) on the
side of the camera.
DISPLAY: Characters and messages showing the camera
settings and operating status may be displayed on the
viewfinder screen.
OFF: Status messages will not appear on the viewfinder
screen.
c
d
e
f g
PGM2 control
Line select switch
MENU: Menus for camera settings will be displayed on the
viewfinder screen.
d MENU SEL (menu select) knob/ENTER button (rotary
encoder)
To select settings from menus displayed on the viewfinder
screen (by turning the knob) and to confirm settings (by
pressing the button). It functions the same as the MENU SEL
knob/ENTER button (page 5) on the side of the camera.
e RET 2 (return video 2) button and select switch
When using another system line in parallel with return video 1,
use to switch between the video signal of the unit and the
return video signal. The video signal is displayed on the
viewfinder screen.
Note
The RET 1 button has priority over the RET 2 button if both
buttons are pressed.
If RET 1 and RET 2 buttons are pressed at the same time, the
two buttons function as the RET 3 button according to the
setting on the <RETURN> page of the OPERATION menu.
f LIGHT switch
Set to ON to illuminate the operation panel.
g ASSIGN (assignable) switch 2
You can assign a function using the menu displayed on the
viewfinder screen.
h INTERCOM1 and INTERCOM2 controls and switches
There are PGM1 and 2 controls incorporated with a line select
switch, a MIC switch, and INCOM level control each for
intercom line 1 and 2.
PGM1 (program 1) control
Adjust the audio listening level of program 1.
PGM2 (program 2) control
Adjust the audio listening level of program 2.
MIC (microphone) switch
ON: The intercom headset microphone is turned on. The
intercom audio listening level is adjusted with the INCOM
level control.
OFF: The intercom headset microphone is turned off. The
intercom audio listening level is adjusted with the INCOM
level control.
INCOM (intercom) level control
Adjust the intercom audio listening level.
Line select switch
Select the intercom line.
PROD: Producer line
ENG: Engineer line
6
Advertisement
Table of Contents
