Throttle Cable Adjustment - Shindaiwa B450 Owner's/Operator's Manual

Assembly of the Handle
T350
WARNING!
NEVER operate this machine
without the front handle. Oper-
ating without the front handle may result
in serious injury.
NOTE:
Tighten four bolts diagonally to properly
secure the handle.
NOTE:
Adjust the handle at the best position for
operator comfort.
(1) Put four square nuts in the recess-
es on the underside of the barrier.
(2) Fit the handle and barrier over the
outer tube and tighten four bolts in a
crisscross fashion.
HANDLE
OUTER TUBE
BARRIER
BOLT
NUT
Assembly of the Handle
C350/B450
(1) Loosen the two bolts of the lower
cap and remove the lower cap.
(2) Position the handle bracket
against the handle label located on
the outer tube.
(3) Attach the lower cap with the two
bolts and tighten the bolts. Make sure
the front handle is in position per the
illustration.
(4) Secure the cable to the outer pipe
with the two bands as the illustration
shows. The two bands are in the tool
bag.
HANDLEBAR
HANDLE BRACKET
HANDLE LABEL
BARRIER
BAND

Throttle Cable Adjustment

(1) Pull the throttle trigger gently,
(2) If free-play is out of specifications:
THROTTLE GRIP
BOLT
LOWER CAP
and check for free-play of
approximately 5mm.
(a) Slide the cable cap toward the
muffler side until the adjusting
nut and the lock nut appear.
(b) Loosen the lock nut slightly.
(c) Turn the adjusting nut so that
free-play is about 5mm.
(d) Then, tighten the lock nut.
(e) Slide the cable cap back.
THROTTLE CABLE
ADJUSTING NUT
LOCK NUT
CABLE CAP
9