Table of Contents
Advertisement
Troubleshooting Continued .....
There is enough water in the
water tank, but the indicator to
"add water" stays on and the
unit will not function.
Ice cube sizes are inconsistent
There is not enough ice cubes
in the ice basket, but the
indicator of "ice full" is on.
Dometic LLC
2320 Industrial Parkway
Elkhart, Indiana 46516.
574-294-2511
Canada
Dometic LLC
46 Zatonski, Unit 3
Brantford Ont. N3T5L8
Canada
51 9-544-4881
For Service Center Assistance
800-544-4881
Form No.: R06010101DP0
The water filter on the bottom of
the water tank may be blocked.
The ice case panel may not be
level.
The room temperature may be too
°
low, around 50
F.
The ice cubes being formed may
be touching the sensor
occasionally when the ice case
panel pushes the ice cubes into
the ice basket.
8
Remove the water filter and clean it.
After following the procedure outlined in
#8 under the "Using your lcemaker"
section, if your icemaker still does not
start producing ice please try the
following two procedures:
1) F ollow the steps outlined in #8,
then wait approximately 5-1 0
minutes and press the 'Power'
button again.
2) Unplug the unit's power supply,
wait approximately 5-10 minutes,
plug the power supply back in,
follow the steps outlined in #8.
Adjust the ice case panel and make sure
it is level.
Make
sure the unit is in an area where
the temperature is above 50
regulated.
Remove the ice cubes, wait for a few
minutes to let the unit restart again.
www.dometicusa.com
°
F
Hide quick links:
Advertisement
Table of Contents
