Hanging The Printer On A Wall - Epson TM-T20III Technical Reference Manual

Hanging the Printer on a Wall

To securely hang the printer on a wall, follow the steps below.
• Hang the printer on a wood, concrete, or metal wall. The thickness of the wall should be 10 mm
{0.4"} or more.
• Be sure to use metallic screws.
• The screws to be put into the wall must have a pull-out strength of 150 N (15.3 kgf ) or more.
1
Put two screws (diameter: 4 mm {0.16"}, head diameter: 7 to 9 mm {0.28 to 0.35"}) into
the wall at an interval of 80 mm {3.15"}.
Make sure the length of the screw in the wall is 10 mm {0.39"} or more, and the length outside the
wall is 3 to 4 mm {0.12 to 0.16"}.
2
Remove the two screws from the printer, and then attach the wall hanging bracket to
the printer using the screws.
3 to 4 mm {0.12 to 0.16"}
7 to 9 mm
80 mm
{0.28 to 0.35"}
{3.15"}
10 mm {0.39"} or more
Screws
Chapter 2 Setup
4 mm
{0.16"}
Wall hanging bracket
25