Cleaning And Preventative Maintenance - Pedigo ivNow Series Operation & Care Manual

Table of Contents

Advertisement

Cleaning and Preventative Maintenance

The cleanliness and appearance of this equipment will contribute considerably to its operating efficiency. Make certain
the module is kept free of any debris that may accumulate. Good equipment that is kept clean works better and lasts
longer.
Clean the Unit Regularly:
1. Turn the unit off.
2. Disconnect the module from the power source.
3. Wipe the metal, plastic, control surfaces, and sensor switch of the module with
a cloth dampened with isopropyl alcohol or 10% bleach solution to clean and
disinfect the unit Avoid the use of abrasive or corrosive cleaning compounds
Avoid contact with the electrical connections and electrical components.
4. Wipe surfaces with a cloth dampened with clean, warm water.
5. Wipe dry with a clean cloth Always follow appropriate state or local health
(hygiene) regulations regarding all applicable cleaning and sanitation
requirements.
NOTE: In the event that fluid should spill inside the module, unplug the unit to prevent
an electrical shock hazard. Wipe excess fluid from module immediately. Refer to
qualified service personnel. Qualified service personnel should remove the module
control and remove any remaining liquid Perform necessary hospital electrical safety
checks before returning the unit to operation.
Annual Preventative Maintenance
1. Ensure that the correct Operation and Care Manual is available to all users.
2. Ensure that all users have been properly trained in unit's operation.
3. Inspect condition of plug and cord. Replace if damaged.
4. Clean dust from the unit.
5. Check condition of wall mounting hardware. Ensure mounting screws and assembly are secure.
6. Check control panel overlay condition. Are there any tears or excessive wear on the graphic? Does the control
work properly when buttons are pushed?
7. Check that all display LEDs light up. Test by turning the unit off and then on All LEDs illuminate for one second
at start-up.
8. Contact the Pedigo Service department for immediate repair if any problems exist.
12

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ivnow-2Ivnow-1Ivnow-3

Table of Contents