Information that you will need to provide for servicing - key information is highlighted. Date of Purchase Serial Number Name of Owner / Facility / Department Weight Capacity Name of Authorized Pedigo Dealer Telephone # of Authorized Pedigo Dealer Address of Authorized Pedigo Dealer...
Safety Instructions The primary concern of Pedigo is that this equipment is operated and maintained with the safety of the patient and staff in mind. To assure safer and more reliable operation: • Read and understand this manual before attempting to install or operate the stretcher.
Explanation of Safety Symbols and Notes Indicates a hazardous situation, that, if not avoided, will result in death or serious injury. This signal word is limited to the most extreme situations. Indicates a hazardous situation, that, if not avoided, could result in death or serious injury.
Installation Unpacking The P-172 stretcher weighs approximately 95 lbs (43 kgs) without options. Get an assistant if necessary and use proper lifting techniques . Failure to do so could result in serious injury. To avoid damaging the stretcher’s upholstered top or other components, do not use a knife or other sharp object to open the stretcher’s packaging.
Description Introduction The P-172 General Transport Stretcher is a fixed height stretcher which is primarily used to support and transport patients in any treatment or procedures environment. Features • Half length, tuck-away side rails that prevent finger pinching, allows closer access to the patient, and allows for a zero transfer gap for easier patient transfer.
Controls and Indicators The illustrations below shows the location of the stretcher’s controls and indicators. The table below describes their function Reference / Control Function Fowler Handles Fowler handles allows the fowler (back) section to be raised or lowered. See “Fowler Positioning”...
Options & Authorized Accessories The options and accessories that are authorized for use with the P-172 stretcher are listed below . Option Name - Factory Install Required Option Number Installed Storage Shelf- Stainless Steel P-170-1 Side Rails - Stainless Steel...
Stretcher Operation Brake and Steering Controls Individual pedals control the steering and braking functions on each casters. The function is indicated by the color of pedal. Pedal functions and positions are illustrated below: Engage steering by pressing down on the green pedal on at least one caster before rolling the stretcher down the hall.
Side Rails Option - P-170-2 To lower the side rail: 1. Grasp the side rail (1) firmly with one hand. 2. Maintain grip on side rail while pulling the release latch handle (2) away from the stretcher. 3. Gently lower the side rail (1). To raise the side rail: 1.
Fowler Option - P-170-3 The Fowler (1) can be positioned 6 different positions between (3˚) and (44˚). To raise or lower the Fowler, do the following: 1. Firmly grasp the end of the Fowler (1), located on the head end of the stretcher. 2.
Locating Sockets for I .V . Poles Option - P-170-4 I .V . Poles Socket Locations There are two I.V. Pole sockets (1) on the stretcher when the I.V. Pole Option is installed. They are located on the opposite corners, one at each end of the stretcher. An additional I.V. Pole Option can be added to make I.V.
Maintenance Cleaning Mattress Cover Regular care should be maintained by daily wiping with a damp cloth or sponge, and periodic cleaning with a mild soap and water solution. The mattress cover material is resistant to most medicinal-type stains, but may be damaged by solvents and dyes. Remove any fluids which are spilled on the upholstery immediately.
Soils or Stains: Use neutral soap suds and lukewarm water. Do not use harsh cleansers, solvents or detergents. Hard-To-Clean Spots: Use standard household/vinyl cleansers and a soft bristle brush on troublesome spots or stains. Pre-soak heavy, dried-on soil. Painted Metal Surfaces: Wipe all painted metal surfaces with a clean cloth at least once a week. Unpainted Metal Surfaces: Wipe all unpainted metal surfaces with a clean cloth.
Scheduled Maintenance Inspection or Service Action* Moving parts Lubricate with lithium white grease or petroleum jelly, except linkages, which should be lubricated with Teflon or Silicon based lubricant . Caster pedal labels If labels are missing, replace as necessary . Warning &...
Pedigo’s obligation under this warranty is limited to the repair or replacement, at Pedigo’s option, of the parts or the products the defects of which are reported to Pedigo within the applicable warranty period and which, upon examination by Pedigo, prove to be defective.