Important Hints - Hameg HM8037 Manual

Important hints

The operator should not neglect to carefully read
the following instructions and those of the
mainframe HM 8001-2, to avoid any operating errors
and to be fully acquainted with the module when
later in use.
After unpacking the module, check for any
mechanical damage or loose parts inside. Should
there be any transportation damage, inform the
supplier immediately and do not put the module
into operation.
This plug-in module is primarily intented for use in
conjunction with the Mainframe HM 8001-2. When
incorporating it into other systems, the module
should only be operated with the specified supply
voltages.
Installation
The instrument may be
installed either right or left
in the HM 8001-2. Just shove
it into the mainframe until the
backside connector engages
which may need somewhat more force. Correct
insertion is achieved if the module sits appr.
3 .. 4 mm inside the frame of the HM 8001-2.
Transport
Conserve the packing material in case you may
need it later for shipping the instrument. Any
transport damages caused by unsuitable packing
will void the warranty.
Safety
This instrument has been designed and tested in
accordance with IEC Publication 1010-1, Safety
requirements for electrical equipment for
measurement, control, and laboratory use . It
corresponds as well to the the CENELEC regulations
EN 61010-1. All case and chassis parts are connected
to the safety earth conductor. Corresponding to
18
Safety Class 1 regulations (three-conductor AC po-
wer cable). Without an isolating transformer, the
instruments power cable must be plugged into an
approved three-contact electrical outlet, which
meets International Electrotechnical Commission
(IEC) safety standards.
WARNING!
Any interruption of the protective conductor
inside or outside the instrument or discon-
nection of the protective earth terminal is
likely to make the instrument dangerous. In-
tentional interruption is prohibited.
The istrument must be disconnected and secured
against unintentional operation if there is any
suggestion that safe operation is not possible.
This may occur:
I
if the instrument has visible damage,
I
if the instrument has loose parts.
I
if the instrument does not function,
I
after long storage under unfavourable
circumstances (e.g. outdoors or in moist
environments),
I
after excessive transportation stress (e.g. in poor
packaging).
When removing or replacing the metal case, the
instrument must be completely disconnected from
the mains supply. If any measurement or calibration
procedures are unavoidable on the opened-up
instrument, these must only be carried out by
qualified personnel acquainted with the danger
TRIPLE POWER SUPPLY HM 8040-3
FUSE FUSE
ON/OFF involved.
ON/OFF
OUTPUT
HAMEG
PUSH LONG
VOLTAGE CURRENT VOLTAGE CURRENT
Symbols as Marked on Equipment
Operating conditions
The ambient temperature range during operation
should be between +10 °C and +40 °C and should
not exceed –40°C or +70°C during transport or
storage. The operational position is optional,
however, the ventilation holes on the HM 8001-2
and on the plug-in modules must not be obstructed.
Warranty
Before being shipped, each plug-in module must
pass a 24 hour quality control test.
Änderungen vorbehalten / Subject to change without notice
ATTENTION refer to manual.
DANGER High voltage.
Protective ground (earth) terminal.