Advertisement

Quick Links

I E E E - 4 8 8 ( G B I P )
I N T E R F A C E
H O 7 4 0
Fitting Instruction
English

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IEEE-488 and is the answer not in the manual?

Questions and answers

Summary of Contents for Hameg IEEE-488

  • Page 1 I E E E - 4 8 8 ( G B I P ) I N T E R F A C E H O 7 4 0 Fitting Instruction English...
  • Page 2 General information regarding the CE marking HAMEG instruments fulfi ll the regulations of the EMC directive. The conformity test made by HAMEG is based on the actual generic- and product standards. In cases where different limit values are applicable, HAMEG applies the severer standard. For emission the limits for KONFORMITÄTSERKLÄRUNG...
  • Page 3 C o n t e n t Declaration of conformity General information regarding the CE marking 2. Safety hints 3. Interface Description 4. Oscilloscope Firmware 5. Interface Fitting Instruction 6. Functions and settings 7. Appliance Änderungen vorbehalten...
  • Page 4: Safety Hints

    Internet and actualise the oscilloscope. The fi rmware can be found and download under: Products > Oscillos- If the safety rules are disregarded any damage to HAMEG In- copes > (oscilloscope type) > Software/Firmware (below struments GmbH products will void the warranty. Neither will the oscilloscope picture) >...
  • Page 5 Abide STOP this connection during the fi tting/removing! Only handle the interface by its IEEE-488 socket!! 5.2.1 Insert the interface HO740 in the opening in such a way, that the PCB will be inserted in the guidance - visible on both sides –...
  • Page 6: Functions And Settings

    6.6 Bus driver (E1) 6. Functions and settings The IEEE-488 bus data and control lines are controlled by dri- vers with open collector outputs. As to be seen in IEEE-488.1 standard, this enables a data rate of up to 250000 Bytes per 6.1 Flow control (SH1, AH1)
  • Page 7 A p p l i a n c e 7. Appliance The SCPI programming commands list will be provided in the Internet under www.hameg.com: Service&Support > Down- loads > Software/Firmware: Software Commands for Oscillos- copes HM1008, HM1508 and HM2008. Mainhausen, Germany May 2007 Änderungen vorbehalten...
  • Page 8: Spectrum Analyzer

    . h a m e g . c o m Subject to change without notice 21-05-2007-gw HAMEG Instruments GmbH © HAMEG Instruments GmbH Industriestraße 6 A Rohde & Schwarz Company D-63533 Mainhausen ® registered trademark Tel +49 (0) 61 82 800-0 DQS-Certifi...

This manual is also suitable for:

Ho740

Table of Contents