Built-In Installation - Whirlpool 400011239758 Instructions For Use Manual

BUILT-IN INSTALLATION

Verify the minimum measurements required for correct instal-
lation of the appliance. The co ee machine must be installed in
a column and the column must be rmly xed to the wall with
commercially available brackets.
• Kitchen furniture in direct contact with the appliance must
be heat resistant (65°C min).
• To guarantee correct ventilation, leave a gap at the bottom
of the cabinet (see measurements in gure 1).
• Position the rails on the sides of the cabinet as shown in the
gure 2. Fix with the screws provided, then extract them
completely.
Position and x the lock hook with the four screws provid-
ed, as shown in the gure placing it in the centre of the
cabinet, ush with the front wall.
If the co ee machine is installed over a warmer drawer, use
the top surface of this as a reference to position the rails
( g. 2A).
In this case, there will be no surface to rest the rails on and
the retaining hook must not be installed.
• Fix the power cable with the clip ( g. 3). The power cable
must be long enough to allow the appliance to be extracted
from the cabinet to ll the co ee bean container.
The appliance must be earthed in compliance with legis-
lation.
Electrical connections must be performed by a quali ed
electrician following the instructions.
• Position the appliance on the rails, making sure the pins
are correctly inserted in the housings, then x it with the
screws supplied ( g. 4). If the height of the appliance re-
quires adjusting, use the spacer disks provided.
• If necessary, correct alignment of the appliance by position-
ing the spacers supplied under or at the sides of the support
( g. 5-6).
• To lift the appliance in the front (max 2 mm), turn the latch
as shown in gure 7.
14