Injecting Sealant And Air; Setting Up The Jack - Acura TLX 2020 Owner's Manual

HANDLING THE UNEXPECTED
7. Place a wheel block or rock in the
front and rear of the wheel
diagonal to the flat tire.
8. Place the compact spare tire (wheel
side up) under the vehicle body,
near the tire that needs to be
replaced.
9. Loosen each wheel nut about one
turn using the wheel nut wrench.

Injecting Sealant and Air

1. Remove the valve cap from the tire valve stem.
2. Remove the sealant/air hose from the packaging.
3. Attach the sealant/air hose onto the tire valve stem. Screw it until it is
tight.
4. Plug in the compressor to the accessory power socket.
5. Start the engine. Keep the engine running while injecting sealant and
air.
6. Turn the selector switch to REPAIR (for U.S. models) or SEALANT/AIR
or PRODUIT ANTIFUITE/AIR (for Canadian models).
130 |
7. Press the inflator switch to turn on the compressor.
8. Unplug the power plug from the accessory power socket.
9. Unscrew the sealant/air hose from the tire valve stem. Reinstall the
valve cap.
10. Press the pressure relief button until the gauge returns to 0 psi (0 kPa).
11. Apply the repair notification label to the flat surface of the wheel.

Setting Up the Jack

n
1. Place the jack under the jacking
point closest to the tire to be
changed.
2. Turn the end bracket clockwise (as
shown in the image) until the top
of the jack contacts the jacking
point. Make sure that the jacking
point tab is resting in the jack
notch.
HANDLING THE UNEXPECTED
| 131