Wiper Operation; Turning The System On Or Off; Front Wipers; Headlight Integration With Wipers - Acura TLX 2020 Owner's Manual

VEHICLE CONTROLS
n

Turning the System On or Off

Make sure the headlight lever is in the
low beam position with the switch
rotated to the AUTO position. The
auto high beam system indicator
comes on.
To turn the system Pull and hold the headlight lever toward you for
on: about 30 seconds, until the indicator flashes once.
To turn the system Pull and hold the headlight lever toward you for
off: about 40 seconds, until the indicator flashes twice.

Wiper Operation

The windshield wipers and washers can be used when the vehicle is on.

Front Wipers

n
Move the wiper lever up or down to the desired position.
n

Headlight Integration with Wipers

When the headlights are in the AUTO position, they automatically turn on
when the front wipers operate several times within a certain interval. The
headlights turn off shortly after the wipers are turned off or if there is
enough ambient light.
46 |
*1
n Intermittent (INT) Wipers
When you move the lever to the INT
position, the wipers operate based on
the delay adjustment.
Rotate the adjustment ring to adjust
the wiper delay.
*1
n Automatic Intermittent Wipers
When you push the lever down to
AUTO, the windshield wipers sweep
once, and go into the automatic mode.
The wipers operate intermittently, at
low speed, or at high speed and stops
in accordance with the amount of
rainfall the rainfall sensor detects.
Turn the washers off if no washer fluid comes out. The pump may get
damaged.
AUTO should always be turned OFF before the following situations in
order to prevent severe damage to the wiper system:
• Cleaning the windshield
• Driving through a car wash
• No rain present
Operating the wipers in this condition may damage the wipers. Use the
defroster or heated windshield
wipers on.
VEHICLE CONTROLS
*1
to warm the windshield, then turn the
*1 - If equipped
| 47