Turbo-V 1K-G Navigator Controller Installation; Bottom Mounting - Agilent Technologies Turbo-V 1K-G Series User Manual

17 Technical Information

Turbo-V 1K-G Navigator Controller Installation

Turbo-V 1K-G Navigator Controller Installation

The controller can be mounted on the pump bottom.
To install the controller execute the following procedures.

Bottom mounting

See the following figure.
1
2
3
4
5
6
7
292/304
Turn the pump upside-down;
Place the three washers on the pump bottom in correspondence
of three hole at 120°;
Place the controller on the washers, with the pump cable toward
the pump body;
Fix the controller to the pump bottom by means of the three
socket head screws M5;
Turn the pump again;
Plug the line card and connect the pump cable to the pump;
Connect the mating connector with the jumper on the interlock
signal to start the pump.
Turbo-V 1K-G User Manual / 87-901-025-01 (A)