Operation & Set Up - Dimplex DCMIST30 Instruction Manual

Operation & Set Up
1. Remove the unit from its packaging.
2. Remove the water tank and turn upside down and remove the lid. Fill the water
tank with cool, filtered water. Do not over fill.
3. Replace the water tank into the unit, and plug the cord into a power outlet. .
4. Press the ON/SPEED button to turn the unit ON. The unit will start in medium
speed then to low speed. Cycle through the speeds as required.
5. Press the MIST button to start the misting function.
6. Use the ICE PACK as described on the previous page.
7. The unit will operate initially on a continual basis. If a set period of operation is
required, please follow the TIMER instructions on the previous page.
8. Press the SWING button as required.
9. To switch the unit off at any time, press the OFF button.
Precautions
• Do not overfill the water tank (check the MAX fill line).
• Always check the water level prior to using the mist function.
• Use only cold, clean filtered water.
• For safety reasons the unit will turn OFF when the water tank is removed.
• Do not allow the same water to sit in the machine for a prolonged period.
• It is recommended that any water left in the machine for 3 days or more be re-
moved and replaced with clean water.
• The control panel must not come in contact with water or any other liquids.
• Make sure the tank lid is secure and tight before placing back into the unit.
Using the Remote Control
1. Open the battery cover of the remote control, and insert a 3V CR2032 battery.
2. Please point to the receiver when using the remote control.
3. If the battery voltage is low, please open the battery cover as per the diagram
and replace with a new battery (CR2032). Then replace the battery cover.
9