Page 1
INSTRUCTION MANUAL Alden SmartHome Purifying Bladeless Fan Model: DCMFBHSH For domestic household use only.
Page 2
IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Note also the information presented on the appliance CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY Please read the operating instructions carefully before using your fan for the first time and keep them in a safe place.
Page 3
• To avoid a fire or electrocution hazard, NEVER put the cord near heat registers, radiator, stoves or heaters. • DO NOT cover cord with carpeting, throw rugs, runners, or similar coverings. • DO NOT route cord under furniture or appliances. Take care to position the cord away from traffic areas and where it will not be a tripping hazard.
Page 4
Exposed to the Near water If the power cable weather outdoors wires are frayed or cut Where small children If an extension Where the power may be left unattended lead may become cable may be overloaded damaged On a slope or Where there is risk Where it may be uneven surface...
Specification Model no. DCMFBHSH Rated voltage 24VDC Rated voltage/frequency for adaptor 100-240V 50/60Hz Rated power Speed settings Modes Sleep & Strong Timer 0-8hr Wind flow (max) 3.5m/s Motor Controls Touch or remote Oscillation 80 degrees Noise level ≤55dB Weight 2.84kg Dimensions (w x d x h) 235 ×...
Page 6
Parts Air outlet Air duct Top cover of air purifier filter Air inlet Touch screen button/ LED display Base Air duct Top cover of air purifier filter Air inlet Body Power connection...
Fan Operation A. Assembly This bladeless fan comes fully assembled. Please remove any packing materials prior to first use. Screw B. Battery Installation 1. Unscrew and remove the battery cover at the back of remote control Buckle 2. Insert the CR2025 battery 3.
Page 8
Fan Operation D. LED Display The fan can also be controlled by pressing the LED Display, however not all settings can be accessed this way. Refer to the ‘Operation’ section for instructions. The remote control should be pointed at the remote control signal receiver on the display to maximize the remote control signal.
Operation ATTENTION: PLEASE READ THIS MANUAL CAREFULLY BEFORE CONNECTING DEVICE TO THE POWER SUPPLY. CHECK THE VOLTAGE MATCHES THE UNIT RATING BEFORE OPERATING. (RATED ELECTRIC POWER FOR POWER ADAPTOR: 220-240V; 50 Hz). WARNING - THIS APPLIANCE IS FOR USE ONLY WITH THE SUPPLIED POWER ADAPTER.
Operation LED DISPLAY OPERATION Some functions can be operated by pressing the LED Display. To have full use of all functions, please use the remote control. 1. Hold fan body with one hand and set the 15° 15° wind outlet to the desired angle. 2.
Operation Filter Replacement Reminder: After 720 hours of use, when the purifying bladeless fan is turned on, it will beep 5 times and after 5 seconds, the LED screen will light up and display and cycle through icons as shown on image below. After the filter has been replaced, press the power button on the remote control for 5 seconds to clear and reset the Filter Replacement Reminder.
Need help?
Do you have a question about the DCMFBHSH and is the answer not in the manual?
Questions and answers