What To Do If The Crockery Warmer Doesn'twork; Installation Instructions - Electrolux WS140SL User Manual

WHAT TO DO IF THE CROCKERY WARMER DOESN'T
WORK
WARNING!
Any type of repair must only be done by a
specialised technician. Any repair done by a
person not authorised by the manufacturer is
dangerous.
Before contacting
check on the following:
 The crockery doesn't heat up enough.
Check whether:
 The appliance has been switched on.
 The appropriate temperature has been
selected.
 The air circulation orifices are covered by
the crockery.
 The crockery was left to heat up for
sufficient time.

INSTALLATION INSTRUCTIONS

WARNING!
Read the "Safety Information" carefully for
your safety and correct operation of the
appliance before installing the appliance.
Before installation
Check that the input voltage indicated on the
characteristics plate is the same as the
voltage of the power outlet you are going to
use.
Open the drawer and take out all the
accessories and remove the packing material.
WARNING!
The front surface of the crockery heater may
be wrapped in a protective film. Before using
the crockery warmer for the first time, remove
this film carefully.
Make sure that the crockery warmer is not
damaged in any way. Check that the drawer
opens and closes correctly. If you find any
damage, contact the Technical Assistance
Service.
ATTENTION:
The power socket should be easily accessible
after the crockery warmer has been installed.
Technical Assistance,
 Heating time depends on several factors,
such as, for example:
 Crockery material type and thickness.
 Quantity of crockery.
 How the crockery is arranged.
 The crockery doesn't heat up at all. Check
whether:
 You can hear the noise of a fan.If the fan
is operating then the heating element is
broken; if the fan is not operating then the
fan is broken.
 The switchboard fuses / circuit breakers
have fused / tripped out.
 The crockery is heating up too much, check
if:
 The thermostat selector is broken.
 The on/off switch does not light up, check if:

The switch's pilot light has blown.
The crockery warmer should only be built-in in
combination with those appliances indicated
by the manufacturer.
Installation
To build-in the
combination with another appliance there
must be a fixed, interim shelf in the housing
unit to support the weight of both appliances.
The appliance to be combined with the
crockery warmer will be placed directly on the
latter without any need to have a separating
shelf.
To build-in the appliance which is combined
with the crockery
instructions set
instructions and fitting booklet.
The relevant installation dimensions are
indicated in mm in the diagrams shown at the
end of this booklet. Proceed as follows:
1. Place the crockery warmer on the shelf
and slide it towards the interior of the
niche in such a way that it is centred and
completely lined up with the front of the
unit.
2. Check that the crockery warmer's frame is
properly levelled and is sitting evenly on
the shelf.
ENGLISH
crockery warmer
warmer, follow
out in the respective
59
in
the