Please Read and Save Product Registration This Guide Card Thank you for choosing Electrolux, the The package containing this manual new premium brand in home appliances. also includes your product registration This Use & Care Guide is part of our information.
Finding Information Table of Contents Finding Information ..............2 Please Read and Save This Guide ............2 Make a Record for Quick Reference ............2 Product Registration Card ...............2 Questions? ....................2 Safety ....................4 Important Safety Instructions ..............4 Safety Precautions ................4 Definitions ...................4 General Precautions ..............4 Installation ...................5 Installing the Refrigerated Drawers ............5 Site Preparation ..................6...
Allow unit temperature to IMPORTANT stabilize for 24 hours before use. Indicates installation, operation, or CAUTION maintenance information which is important but not hazard-related. • Use only genuine Electrolux replacement parts. Imitation parts can damage the unit and may void the warranty.
¼ inch over the dimensions given for your unit. NOTE All units require zero clearance when installed flush with a cabinet or wall. Electrolux stainless steel models require a minimum 2 ⁄ inch handle clearance when installed against a wall or cabinet that extends beyond the front edge of the unit.
Installation Site Preparation Installing the Anti-Tip Device 1 Position the unit on a flat, level surface capable of supporting the WARNING entire weight of the unit. Remember the unit will be significantly heavier once it is fully loaded. Do not double stack two units as shown below.
Installation 3 Make sure the Refrigerated Drawers CAUTION are in the desired location, then mark on the floor the rear and side corner of Any finished flooring should be the cabinet where the anti-tip bracket protected with appropriate material to will be installed.
Operation Temp Temp System Based on EGD/Larger Carrier Minus On/Off Plus Lock Status keypad keypad keypad Display Area keypad indicators door ajar power failure temp on-off lock air filter alarm reset Electronic Control Display To wake the display press any keypad. A confirm tone will sound, and the current storage compartment temperature will be Power Failure...
Operation on-off Temperature mode: Adjusting the temperature: The temperature mode is preset from the To set or check the set-point temperature factory in Fahrenheit (°F) but you have the (with the control out of sleep mode), option to change it to Centigrade (°C). To press the "-"...
Operation Alarms The control will alert you to conditions that could adversely affect the performance of on-off the appliance. Temp alarm reset Temperature alarm - If the storage Door Ajar compartment temperature exceeds 10°F on-off from set-point for more than a one hour alarm reset duration, the System Status indicator will turn off, the "Temp"...
Operation on-off Air Filter alarm reset Air Filter - The control will notify you as to when it is time to replace the air filter (every six months). The System Status indicator will turn off and the "Air Filter" indicator will flash.
Removing the Drawer WARNING ELECTROCUTION HAZARD • Never attempt to repair or perform maintenance on the appliance until the main electrical power has been disconnected. Turning the appliance control “OFF” does not remove electrical power from the units wiring. • Replace all parts and panels before operating.
Care & Cleaning and Energy Saving Tips In the Event of a Power Failure Bottom drawer divider If a power failure occurs, try to correct it as soon The bottom drawer has a divider that can as possible. Minimize the number of drawer be flipped up or down depending on your openings while the power is off so as not to preference.
1-877-808-4195, visiting impossible to remove. www.electroluxappliances.com, or seeing the dealer where you bought your Refrigerated Drawers. Electrolux CAUTION recommends that you order extra filters when you first install your Refrigerated • Stainless steel models exposed to...
If the product is within the first year warranty period please contact your Open the drawer, squeeze the grille (top dealer or call Electrolux Customer and bottom) which will release the tabs on Service at 877.435.3287 for the grille and pull it toward you to remove directions on how to obtain warranty from the cabinet.
Temperature” in the “Start-Up and Temperature Control” section). No interior light. • Failed LED assembly. • Contact a qualified Electrolux Service Technician. Light will not go • Manual light control • Turn off manual light control. out when drawer is is ON.
Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will repair or replace any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used, and maintained in accordance with the provided instructions.