Important
Leave the main power switched on at all times.
Never switch off the main power. By switching on the main power, the automatic maintenance function is carried out periodically. If the automatic maintenance is not carried out, it may
result in a machine breakdown, e.g. damage to the print heads.
Never switch off the main power or unplug the power cord during operation.
Switching off the main power or unplugging the power cord during operation may damage the print heads. Be sure to first switch off the sub power. If the main power is accidentally
switched off, immediately turn the main and sub power back on.
Periodic use of the machine is recommended.
We recommend using the machine at least once a week. If left unused for a long period of time, the ink may settle, resulting in unstable discharge (and dot drop-out). Any dry ink will need to
be discharged.
Allow the ink to dry completely.
After output, allow the ink to dry completely. In particular, white ink and metallic silver ink must be printed with a high concentration and takes longer to dry than CMYK ink.
Lamination is strongly recommended.
Because metallic silver ink and white ink may not be as weather resistant as CMYK ink, depending on conditions, we strongly recommend laminating output of metallic silver ink.
Thank you very much for purchasing the BN-20.
This document describes the procedure of "First Time Printing
and Cutting," from installation and setup of this machine to
the actual printing.
About Roland On Support
Using On Support allows you to receive your printer's ink status and error
information as an email sent to your PC and mobile phone. You can also
receive product updates and other support information from On Support.
To install On Support, download from the following URL.
http://download.rolanddg.jp/en/bn_onsupport.html