Instructions For The User - Electrolux ZHTAROW User Manual

C
Our appliances have been studied and optimised to give high performance. This appliance must be used exclusively
for the purpose for which it has been designed, i.e. for washing dishes with water and specific detergents. Any other
use is to be considered improper.
This appliance does not carry out the rinse cycle should there be no supply water; it stops all functions with an error
message "A1" (also see "Warning messages").
• Carry out a couple of cycles without dishes to flush out any industrial grease which has remained in the
tank and piping.
• Avoid washing decorated dishes.
• Do not allow silverware to come into contact with other metals.
• Do not allow food to dry on the dishes.
• Remove large food scraps from the dishes to prevent clogging the filters.
• Pre-wash the dishes by spraying them with cold or lukewarm water, without using any detergent.
• Use automatic dispensers for the detergent.
• If there is no automatic dispenser, pour a non-foaming detergent into the tank when the water has reached
the washing temperature.
L
B
A
K
J
H
LEGEND:
A = on/off
B = drain/self-cleaning cycle
K = display
D = "tank" indicator light
E = "boiler" indicator light
ATTENTION
The GUARANTEED RINSE SYSTEM (GRS) is incorporated in the ACTIVE/ WASH SAFE CONTROL models
(see led "L").
The GRS is an automatic rinse time/temperature control system.
Operation is as follows:
• during the wash cycle the indicator light is OFF;
• during the rinse cycle the indicator light comes on and is GREEN;
• at the end of the rinse cycle the indicator light remains GREEN if the rinse temperature and time have
been carried out as for the program, otherwise the indicator light becomes RED;
• upon opening the hood, the indicator light GOES OUT.
If the indicator light becomes RED, for example should the boiler waiting time be disabled, wait for a cou-
ple of minutes and then repeat the wash cycle.
The temperature shown on the display is that of the boiler if the indicator light "E" is on or of the tank if the light "D" is
on. The tank temperature is displayed during the wash cycle and the boiler temperature during the rinse cycle.

INSTRUCTIONS FOR THE USER

CONTROL PANEL
L L
D
B B
A A
E
K K
F
J J
G
H H
Figure 17
TIPS
L
D D
B
A
E E
K
F F
J
G G
H
J = wash cycle 1
H = wash cycle 2
F = wash cycle 3
G = High productivity / Thermal label cycle
L = Active / Wash Safe Control Led
D
E
F
G
13