Programming Keyless Entry Pad - Craftsman 200.57983 Owner's Manual

Programming Wireless Keyless Entry Keypad
To purchase a wireless keyless entry keypad, visit a Craftsman outlet, call 1-888-331-4569, or go online
To prevent SERIOUS INJURY or DEATH:
- Keep remote and battery out of reach of children.
- NEVER permit children to access the wall panel, push button nor remotes.
- Operate door only when it is adjusted properly with no obstructions to door travel and is in clear sight.
- ALWAYS keep a moving door in sight until completely closed. NO ONE should cross the path of a moving
door.
To reduce risk of fire, explosion or electric shock:
- DO NOT short circuit, recharge, dissemble or heat the battery, batteries may explode or leak.
- Replace with 1.5 volt AAA batteries ONLY. Dispose of batteries properly.
1
LEARN
2
Enter a 1- 6 digit personal
code and press/release
"ENTER"
Fig.2
OK
30
seconds
3
OK
Flashes x2
x2
Fig.1
(2) 1.5 Volt AAA
Alkaline Batteries
WARNING
!
Note: After backup battery has been installed--slide the battery up to
remove the battery from the holster to access the LEARN button to
program new remote controls. Remove the holster to read
programming instructions printed on the opener's back panel next to
the programming buttons.
To Add Personal Codes:
1. Press the "LEARN" button on the rear control panel, "OK" LED
will glow and beep. The unit is ready to accept a keypad code
in the next 30 seconds as shown in Fig.1.
2. Enter a 1 - 6 digit personal code on the keyless entry within 30
seconds and press/release "ENTER" button.
flash and beep twice indicating personal code is stored in
memory.
Up to 20 personal codes (including 1-button remotes) can be added
to the unit by repeating the above procedures.
If more than 20 personal codes are stored, the previously stored one
from the very beginning will be replaced, (i.e. the 21st code replaces
the 1st stored one.)
Operation:
To access the door, enter a pre-stored personal code and press
"ENTER" to transmit code, and within 20 seconds, "ENTER" button
can be used to stop or reverse the door.
If the code is entered incorrectly, correction can be made by pressing
"ENTER" to reset and re-enter code.
When dark, "ENTER" may be pressed in advance to turn on back
light.
Removing ALL Personal Code(s):
To remove ALL personal code(s) and/or transmitters from memory,
press and hold the "LEARN" button for 5 seconds. "OK" LED will
flash and beep, indicating ALL codes/transmitters have been
removed from memory.
Mounting the Keyless Entry:
Keyless entry may be secured on door jamb face outside your
garage. Locate keyless entry within sight of door at minimum height
of 5 feet (1.5m), ensure it is away from reach of children and moving
parts of door and hardware. Test the reception of the keyless entry
before mounting. Change location for better reception if necessary.
Use the mounting holes on the keyless entry as template to mark
position on the mounting surface. To attach to a wooden surface use
the screws provided. In case of a drywall surface, drill holes and use
drywall anchors provided.
Replacing Keyless Entry Battery:
When the battery of keyless entry is low, dimmed illumination is
observed. To replace battery, remove the battery cover by loosening
the screws underneath, and replace the battery with two1.5 volt AAA
batteries.
"OK" LED will
23