Programming 3-Button Remote - Craftsman 200.57983 Owner's Manual

Programming 3-Button Remote

To prevent SERIOUS INJURY or DEATH:
- Keep remote and battery out of reach of children.
- NEVER permit children to access the wall panel nor remotes.
- Operate the door ONLY when it is properly adjusted, and there are no obstructions present.
- ALWAYS keep a moving door in sight until completely closed. NEVER cross the path of a moving door.
To reduce risk of fire, explosion or electric shock:
- DO NOT short circuit, recharge, dissemble or heat the battery, batteries may explode or leak.
- NEVER allow small children near batteries.
- Replace with 27AE 12 volt batteries ONLY. Dispose of batteries properly.
Signal and
Battery Indicator
1
LEARN
2
27AE 12 Volt
Alkaline Battery
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
22
!
Visor Clip
Holster
Fig.1
OK
30
seconds
OK
Flashes x2
x2
Fig.2
Fig.3
WARNING
To Program Transmitter(s):
1. Press/release the "LEARN" button on the rear control
panel, "OK" LED will glow and beep. The unit is now ready
to accept a transmitter in the next 30 seconds as shown in
Fig.2.
2. Press/release the large grey button on the Transmitter.
(Additional buttons used for multiple garage door openers)
3. The "OK" LED will flash and beep
transmitter is stored successfully.
Up to 20 Transmitters (including wireless keypad codes) can be
added to the unit by repeating the above procedures.
If more than 20 Transmitters are stored, the first stored
Transmitter will be replaced. (i.e. the 21st Transmitter replaces
the 1st stored Transmitter.)
Note: After backup battery has been installed--slide the battery
up to remove the battery from the holster to access the LEARN
button to program new remote controls. Remove the holster to
read programming instructions printed on the opener's back
panel next to the programming buttons.
Removing ALL Transmitters:
To remove ALL Transmitters from memory, press and hold the
"LEARN" button for 5 seconds. The "OK" LED will flash and
beep 2 times indicating ALL transmitters have been removed
from memory.
Replacing Remote Battery:
When the battery of the hand held remote is low, the indicator
light will become dim and/or the range of the remote will
diminish. To replace the battery, remove the battery cover from
the remote as shown in Fig 4. Replace with a 27AE 12 volt
alkaline battery with polarity shown in Fig.4.
twice indicating